Oricom CARE920-1 User Manual page 57

Your own voice cannot be announced when the telephone number of
incoming call is same as 1 of 4 photo memories stored
• The ringer volume may be switched off.
• Voice recording in 1 of 4 photo memories was not done successfully. Please
refer to Section "Record your own voice tag" to record again.
• Your telephone line may not be subscribed or availability of the service from
the fixed line operator.
Cordless handset does not ring (Caller Line Identification)
• The ringer volume may be switched off.
• Check that the mains power is correctly connected.
• Make sure the cordless handset is registered to the base.
No display in cordless handset
• The batteries may be flat, faulty or incorrectly inserted.
• Recharge or replace the batteries
Handset displays "PUT ON BS TO POWER"
• Check that the mains power is correctly connected.
• Check that the cordless handset is within range of the base.
No voice tag announcement from cordless handset during ringing
• Wait 1 minute in idle mode without any operation of the phone.
You hear the busy tone when you press
• Make sure the cordless handset is in range of the base.
• Another cordless handset registered to your telephone base may be on the
line.
No sounds or noise when using corded handset
• Make sure the coil cord connector between base and handset firmly plugged in.
No key tone on Base
• Check key tone setting is on.
Buzzing noise on my phone or on other electrical equipment nearby
• Sometimes your phone can interfere with other electrical equipment if it is
placed too close. It is recommended that you place your phone at least one
metre away from electrical appliances or metal obstructions to avoid any risk
of interference.
• If you have an ADSL internet service ensure correct filters are installed to
prevent interference.
Answering machine does not record any messages
• Make sure the answering machine is switched on.
• The memory may be full, please delete some old messages to free up
space.
key on handset
57
Troubleshooting