The Indicator Is Steady Red; The Indicator Is Steady Green; The Indicator Keeps Blinking Green At An Interval Of 0.2S (In Fit Mode); No Wireless Signal Searched Out - Ruijie RG-MAP852-SF-U Hardware Installation And Reference Manual

Hardware Installation Guide
DC power supply: Check whether mains input exists.

6.2.3

The Indicator Is Steady Red

The Indicator keeps steady red for a long time, indicating that the Ethernet port is not
connected. Verify the Ethernet connection.
6.2.4

The Indicator Is Steady Green

The device performs initialization after power-on. The indicator enters the normal state
of quick off after blinking green after initialization is completed. Note: If the steady green
persists for an hour, the device initialization fails and the device is faulty.
6.2.5 The Indicator Keeps Blinking Green at an Interval of 0.2s (in Fit
Mode)
The AP may perform software upgrade after power-on. The indicator keeps blinking
green in this period. After software upgrade is completed, the indicator enters the state
of quick off after blinking green. Note: Software upgrade takes certain time. Therefore,
do not plug or unplug the power cord when the status indicator is blinking. If the blinking
persists for ten minutes, it indicates that the device fails to complete software upgrade
and is faulty.
6.2.6

No Wireless Signal Searched Out

(1) Verify that the device is properly powered.
(2) Verify that the Ethernet port is correctly connected.
(3) Verify that the AP is correctly configured.
(4) Move the client to adjust the distance between the client and the AP.
34
Troubleshooting