Debugging; Establishing The Configuration Environment; Powering On The Ap; Check Before Power-On - Ruijie RG-MAP852-SF-U Hardware Installation And Reference Manual

Hardware Installation Guide
4

Debugging

4.1

Establishing the Configuration Environment

Power on the AP through DC or PoE.
When setting up the environment, pay attention to the following:
When the AP is powered through DC or PoE, ensure that the power cord is properly

connected and meet safety requirements.
Use a twisted pair cable to connect the AP that is powered properly to the AC.

When the AP is connected with a PC, verify that the PC and PoE switch are properly

grounded.
4.2

Powering on the AP

4.2.1

Check Before Power-on

Check whether the power cord is properly connected.

Check whether the power supply voltage is the same as that required by the AP.

4.2.2

Check After Power-on

After power-on, you are advised to check the following to ensure the normal operation of
the AP:
Check whether any message is printed on the configuration interface of the device.

Check whether the indicator is normal.

31
Debugging