KidKraft RIDGEMOOR PERCH SWING SET Manual page 92

Step 37: Crow's Nest Frame
Part 4
M: Place the frame on a hard, flat surface so that the (11186) Bottom Nest Top B is on the bottom and its notch is
facing to the top. (fig. 37.5)
N: Place boards (11185) Bottom Nest Top A and (11184) Crow Nest Floor Support on either side of the left (11183)
Crow Nest Post B. Align the boards so they are flush with the notched edge of (11186) Bottom Nest Top B.
O: Attach 1 (H8) Hex Bolt (with lock washer, 2 flat washers, and lock nut) to the bottom hole. Do not fully tighten
yet.(fig. 37.6)
P: Place (11368) Crow Nest Post A in between the two (11185) Bottom Nest Top A and (11184) Crow Nest Floor
Support. Keep board (11368) square to the other boards and align its first hole with the corresponding top holes
on the other boards. Note the notch cut is not flush with board (11184). (fig. 37.5)
Q: Attach 1 (H8) Hex Bolt (with lock washer, 2 flat washers, and lock nut). Tighten all bolts. (fig. 37.6)
H8
LW1
FW1
11185
5/8"
15.9 mm
Fig. 37.5
Wood Parts
1 x Crow Nest Post A
11368
1 x Crow Nest Floor Support
11184
1 x Bottom Nest Top A
11185
11368
FW1
LN1
11184
H8
11185
H8
11183
2 x
2 flat washer, lock nut)
11368
11184
11186
Hardware
Hex Bolt (lock washer,
H8
92
Fig. 37.6
Flush
Rotated View
LN1
FW1
FW1
11368
11184
11185
LN1
FW1
FW1
Flush
7
LW1
H8
11183
LW1
H8