Advertisement
Step 26: Attach TNR 4 Clamp Rings
A: Place 2 TNR4 Clamp Rings around each joint making sure to match the arrows with the end of the Clamp
Ring as shown in (fig. 26.1 & 26.2 ).
B: Connect TNR4 Clamp Rings in 2 spots using 1 (PB6) ¼ x 1" Pan Bolt (with lock nut) per side. (fig.26.3)
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess.
Fig. 26.1
TNR4
Clamp
Rings
TNR4
Clamp
Rings
Fig. 26.2
Fig. 26.3
After the clamp rings are attached to
the elbows, fasten them end to end
with two pan bolts and lock nuts
Hardware
10 x
1/4 x 1" Pan Bolt (LN1)
PB6
67
PB6
Make sure arrows
are aligned
PB6
10 x TNR4 Clamp Ring
LN1
LN1
Other Parts
Advertisement
