Advertisement
Step 29: Attach TNR Brace Assembly and TNR4 Slide
A: Remove (H9) Hex Bolt from bottom of (2771) End Post then attach (8963) TNR Ground Brace flush to the
bottom of (2618) Front Back Panel with 2 (S11) Wood Screws and 1 (S4) Wood Screw. (fig. 29.1 and 29.3)
B: Place 1 TNR4 Post Mount Clamp on either side of the Clamp Ring so that the bent tops clip in behind the
Clamp Ring.
C: Insert the TNR4 Post Mount Base in between the 2 TNR4 Post Mount Clamps and bolt all pieces together
using one ¼ x 14.5mm Pan Head Bolt and Square Lock Nut. (fig. 29.2)
D: Attach TNR4 Post Mount Base to (8965) TNR Upright, pre-drill with a 1/8" (3.2mm) drill bit then attach with 2
(S6) #12 x 1" Pan Screws. (fig. 29.2)
E: Attach the Post Mount Clamp to the clamp ring using 1 (S37) #7 x 5/8" Pan Screw. (fig. 29.2)
Fig. 29.1
2771
Fig. 29.2
¼ x 14.5mm
Pan Head Bolt
Remove H9 (Hex Bolt)
first from post then
attach TNR Brace
Assembly
8965
TNR Brace
Assembly
Hardware
2 x
#12 x 1" Pan Screw
S6
1 x
#8 x 3" Wood Screw
S4
2 x
#8 x 2" Wood Screw
S11
1 x
#7 x 5/8" Pan Screw
S37
S37
TNR4 Post
Mount Base
S6
100
Fig. 29.3
S11
70
TNR4 Post
Mount Clamp
Square
Lock
Nut
8965
2771
8963
S4
Other Parts
2 x TNR4 Post Mount Clamp
1 x TNR 4 Post Mount Base
1 x 1/4 x 14.5 mm Pan Head Bolt
1 x Square Lock Nut
Advertisement
