Advertisement
Step 28: Attach TNR 4 Slide to Adventure Tower
A: Place TNR Brace Assembly against (2771) End Post Left so it sits under the slide. It is not attached yet.
(fig. 28.1)
B: On the fourth Elbow Assembly attached remove the pan bolt and nut which is facing the fort (installed in Step
23). (fig. 28.1) The bolt will no longer be needed, but keep the lock nut.
C: Loosely attach TNR3 Tube Support (at the slightly bent end) to the Clamp Ring using 1 (PB6) Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 28.2)
D: Rotate TNR3 Tube Support and attach to (2771) End Post Left using 1 (S6) Pan Screw as shown in fig. 28.2.
E: Fully tighten screw and bolt.
Fig. 28.2
TNR 3 Tube
Support
2771
Note: Flat
end down
Remove PB1 (Pan Bolt)
first then install PB6 Pan
Bolt with flat washer)
LN1
FW1
PB6
S6
1 x
S6
1 x
PB6
2771
TNR Brace
Assembly
Hardware
Pan Screw
Pan Bolt (FW1 & LN1 - previously removed)
69
Fig. 28.1
Other Parts
1 x TNR3 Tube Support
Advertisement
