KidKraft RIDGEMOOR PERCH SWING SET Manual page 28

Step 3: Swing Wall Prep
Part 3
It is important to assemble the frame on a flat, smooth surface.
E: Attach (2630) SW Top to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (WB1) Wafer Bolts
(with flat washer) connecting to previously installed t-nuts. (fig. 3.5 and 3.6)
F: Attach (2768) Panel Floor to (2757) LT Post Assembly and (2758) RT Post Assembly with 2 (H9) Hex Bolts
(with lock washer and flat washer) connecting to previously installed t-nuts. (fig. 3.5).
G: Place 1 (2778) SW Ground MOD to each side of (2769) Panel BT Frame, notice the hole locations and attach
with 1 (H10) Hex Bolt (with lock washer and flat washer) per board connecting to previously installed t-nuts. (fig.
3.5 and 3.7).
H: Place 1 (2607) Diagonal under (2778) SW Ground MOD on the right hand side so the top sits against (2758)
RT Post Assembly and loosely attach with 1 (H10) Hex Bolt (with lock washer, flat washer and t-nut). (fig. 3.5
and 3.7).
Fig. 3.5
2630
Fig. 3.6
WB1
2778
Wood Parts
2 x SW Ground MOD
2778
1 x Diagonal
2607
WB1
x 2
2768
FW2
Fig. 3.7
2769
2 x
WB1
2 x
H9
2 x
H10
1 x
H10
H9
x 2
2758
LW1
FW1
2757
Note which bolt holes are used
Hardware
Wafer Bolt (flat washer)
Hex Bolt (lock washer, flat washer)
Hex Bolt (lock washer, flat washer)
Hex Bolt (lock washer, flat washer, t-nut)
28
7
2607
LW1
2769
2778
H10
x 3
FW1
TN1
2778
2778