KidKraft RIDGEMOOR PERCH SWING SET Manual page 27

Step 3: Swing Wall Prep
Part 2
It is important to assemble the frame on a flat, smooth surface.
C: Turn the (2757) LT Post Assembly and (2758) RT Post Assembly over and place 2 (2756) Siding Assemblies
on top so one sits flush with the top of the middle groove and the second fits flush with the top of the bottom
groove. (fig. 3.2 and 3.3)
D: Place (2630) SW Top in the top grooves, (2768) Panel Floor in the middle grooves and (2769) Panel BT Frame
in the bottom grooves so they sit flush to the outside edges of (2757) LT Post Assembly and (2758) RT Post
Assembly. Make sure the assembly is square and bolt holes are aligned, then attach with 4 (S30) Wood Screws
per board. (fig. 3.4).
Fig. 3.2
Top
2757
Top
Fig. 3.3
Fig. 3.4
2630
Align bolt holes
Wood Parts
2 x Siding Assembly
2756
1 x SW Top
2630
1 x Panel Floor
2768
1 x Panel BT Frame
2769
2756
Flush
Notice Orientation of both
(2756) Siding Assemblies.
Flush
Align bolt holes
12 x
S30
2758
S30
x 4
S30
2768
2757
Hardware
Wood Screw
27
2756
Bottom
x 4
2758
Align bolt holes
Flush
S30
x 4
2769