KidKraft RIDGEMOOR PERCH SWING SET Manual page 38

Step 7: Swing End Assembly
A: Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) Hex Bolts (with lock washer,
flat washer and t-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of angle. (fig. 7.1)
B: Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) Hex Bolts
(with lock washer, flat washer and t-nut). Tighten all bolts (fig. 7.1)
C: Install 2 (WB7) Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (2615) SW Upright as shown
in fig. 7.1. IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE CHECKING
OF WOOD.
Fig. 7.1
2613
Wood Parts
2 x Heavy SW Post
2613
1 x SW Upright
2615
1 x SW Support
2616
2616
TN2
FW2
LW2
G4
2 x G7 Hex Bolt (lock washer, flat washer, t-nut)
3 x Hex Bolt (lock washer, flat washer, t-nut)
G4
2 x Wafer Bolt (flat washer & t-nut)
WB7
TN2
2615
Hardware
38
1
FW2
WB7
G7
FW2
LW2
2 2
Notice 2 bolt
holes at top and
orientation of
the angle
TN2