KidKraft RIDGEMOOR PERCH SWING SET Manual page 128

Step 48: Attach Acro and Belt Swings
A: Using 1 Threaded Clip per chain, join 1 Long Swing Chain to each side of the swing belt seat. Make sure to
close the Threaded Clip tightly using an adjustable wrench. (fig. 48.1 and 48.2).
B: Using 1 Threaded Clip per chain, join the Short Swing Chain to the Acro Bar and Acro Handle. Make sure
to close the Threaded Clip tightly using an adjustable wrench. (fig. 48.2 and 48.3)
C: Attach the other end of the swing chains to the Quick Clips attached to the swing hangers and make sure all
Quick Links are tightened. (fig. 48.1)
Short Swing Chain
Swing Seat
Long Swing Chain
Warning!
for bolts protruding beyond t-nuts. Use
extra washers to eliminate this condition.
Bolt must not exceed 1/2 thread
past the nut
Fig. 48.1
Swing Seat
Check entire play centre
Threaded Clips attach
to seat and Acro bar.
Threaded Clip
128
Fig. 48.2
Tighten Clip using
adjustable wrench
Fig. 48.3
Chain Link
Acro Bar
Acro Handles
Other Parts
1 x Acro Bar
2 x Acro Handle
2 x Swing Belt Seat
2 x Short Swing Chain
4 x Long Swing Chain
1 x Quick Link with Thread (6pk)