Step 38: Attach Crow's Nest
Part 1
A: With an adult helper and a ladder, hoist the frame over the (2614) Engineered Beam. Make sure the notch on
the frame is tight to the Beam. (fig. 38.1)
B: Use 2 (11206) Crow Nest Floor B for alignment, make sure the Crow Nest frame is square. (fig. 38.4)
C: Using the swing brackets as a guide, pre-drill holes with a 1/8" (3.2mm) drill bit.
D: From outside the fort assembly attach the brackets to (2630) SW Top with 2 (WL3) Wafer Lag (with lock washer
and flat washer). (fig. 38.1,38.2 and 38.3)
Fig. 38.1
WL3
Fig. 38.2
Wood Parts
2 x
Crow Nest Floor B
11206
2630
LW1
FW1
Flush
2 x
Wafer Lag (lock washer & flat washer)
WL3
2614
Swing
Bracket
Hardware
95
Fig. 38.4
11206
Do not attach!
Use for alignment only, then
put aside until Step 39.
LW1
WL3
FW1
Fig. 38.3
Flush