Download Print this page

KidKraft RIDGEMOOR PERCH SWING SET Manual page 31

Step 4: Frame Assembly

Part 2

B: Place End Wall from Step 2 between the Front Wall and Back Wall noticing the wall orientation. The tops and

bottoms of the walls should be flush. Make sure the walls are square then using the pilot holes as a guide pre-

drill with a 1/8" (3.2 mm) drill bit and fasten the Back Wall to the End Wall and End Wall to the Front Wall with 4

(WL5) Wafer Lags per side. (fig. 4.4)

Fig. 4.4

WL5

Notice Back Wall

overlaps End Wall

End Wall

Back Wall

Hardware

8 x

Wafer Lag

WL5

Swing Wall

Front Wall

Notice End Wall

overlaps Front Wall

F29735