KidKraft RIDGEMOOR PERCH SWING SET Manual page 91

Step 37: Crow's Nest Frame
Part 3
I: Place the 2 previous (11183) Crow Nest Post B on a hard, flat surface with the TN facing down. (fig. 37.3)
J: Place (11186) Bottom Nest Top B at the bottom of the posts, leaving 1" (25.4mm) overhang on either side of the
board. Make sure the assembly is square.(fig. 37.3)
K: Attach (11186) Bottom Nest Top B with 2 (G4) Hex Bolts (with lock washer and flat washer) connecting to
previously installed t-nuts. (fig. 37.3 and 37.4)
L: Attach 2 (S3) Wood Screws. (fig. 37.3 and 37.4)
Fig. 37.3
Fig. 37.4
FW2
11183
Pre-assembled t-nut
Wood Parts
1 x Bottom Nest Top B
11186
Pre-assembled
t-nuts toward inside
11183
G4
S3
LW2
11186
1"
25.4 mm
2 x
2 x
G4
LW2
S3
FW2
Pre-assembled
t-nut
Hardware
Hex Bolt (lock washer, flat washer)
G4
Wood Screw
S3
91
11183
FW2
11186
1"
25.4 mm
Make sure assembly is square.
1
2 2
G4
LW2
S3
1"
25.4 mm
Flush