Table of Contents
Advertisement
7700 MultiFrame Manual
7735AVC-LB Video Composite Encoder and Audio DAC with SoftSwitch
10.2. CONFIGURING THE MODULE FOR FIRMWARE UPGRADES
The following method can be used to upgrade the firmware in the 7735AVC-LB card. The user can also
use the UPGRADE menu item located on the UTILITIES menu to upgrade the firmware.
UPGRADE:
The UPGRADE jumper J16 located at the front of the module is used when firmware
upgrades are being done to the module. For normal operation it should be installed in
the RUN position. See the Upgrading Firmware section of this manual for more
information.
To upgrade the firmware in the module unit pull it out of the frame. Move Jumper J16
into the UPGRADE position. Install the Upgrade cable provided (located in the vinyl
pouch in the front of this manual) onto header J24 at the card edge. Re-install the
module into the frame. Run the upgrade as described in the Upgrading Firmware
section of this manual. Once the upgrade is complete, remove the module from the
frame, move J16 into the RUN position, remove the upgrade cable and re-install the
module. The module is now ready for normal operation.
7735AVC-LB - 40
Revision 1.6
Advertisement
Table of Contents
