Table of Contents
Advertisement
Check Coolant Level
--- every 10 hours (daily)
WARNING: Do not remove cap (2) until the coolant
temperature in the radiator has cooled. Hot steam and
coolant may spout out, possibly causing severe burns.
After the coolant temperature cools, slowly loosen cap
(2) to release the inside air pressure before removing
cap (2).
When the coolant temperature is low, the coolant level must
be above the top of sight glass (3).
If the coolant level is visible, which is halfway between the top
and bottom of sight glass (3), or the coolant level is invisible,
which is below the bottom of sight glass (3), fill coolant until
the coolant level exceeds the top of sight glass (3).
In case no coolant is present in reservoir tank (1), add the
coolant mixture via the cap hole on reservoir tank (1).
When refilling a long life coolant (LLC), use the same
brand product and the same mixture ratio as already
used in the machine.
If only water is refilled, the mixture ratio in the long life
coolant (LLC) is diluted so that anti-rust and antifreeze
effect in the coolant will become diluted and less
affective.
MAINTENANCE
1
OK
7-71
2
MNDB-07-022
3
MNDB-07-021
NO
NO
Sight Glass (3)
MNDB-07-018
Advertisement
Table of Contents
