Change Transmission Oil And Transmission Oil Filter - KCM 70Z7 Operation & Maintenance Manual

Change Transmission Oil and Transmission Oil Filter

--- every 1000 hours (100 hours at first change only)
WARNING:
Unexpected movement of the machine may cause a
serious accident. When parking the machine, place
F-N-R lever (1) in neutral and neutral lever lock (3) in
the lock ( ) position. Then, apply parking brake (2)
and stop the engine.
Before changing oil, install articulation lock bar (4) to
securely hold the front and rear chassis to avoid an
accident due to unexpected machine movement.
Put the cover on the parking brake disk before
replacing the transmission oil filter to prevent
oil from adhering to the parking brake disk. If oil
adhered, clean the parking brake disk by using
cleaning liquid to completely remove oil. Failure to
do so may cause the parking brake to malfunction.
IMPORTANT: Do not use transmission oils other than
those listed in the "Recommended Transmission Oil"
NOTE: Be sure to replace the transmission oil filter when
changing the transmission oil.
1. Operate the machine until the transmission oil is heated
to the appropriate temperature.
2. Park the machine following the same procedures as
described on page 7-7 for preparation of inspection/
maintenance work.
3. Install articulation lock bar (4) to the front and rear of the
chassis by following the procedures described on page
7-9.
MAINTENANCE
1
7-35
2 3
4
MNDB-01-001
MNEC-07-004