Replace Fuel Pre-Filter Element - KCM 70Z7 Operation & Maintenance Manual

Wheel loader
Table of Contents

Advertisement

Replace Fuel Pre-Filter Element

---every 500 hours
IMPORTANT:
Be sure to use only genuine Kawasaki elements
for the main fuel filter and the pre-filter. Failure
to do so may deteriorate the engine performance
and/or shorten the engine service life. Please be
noted that all engine failures caused by using
other manufacturers' elements are excluded from
Kawasaki Warranty Policy.
Take care not to allow dirt and/or water to enter the
fuel tank.
Procedures
1. Remove cartridge filter (1) by using a filter wrench.
Arrange a container to receive fuel for safety and to
prevent ground from contamination.
2. Apply a thin film of clean fuel to the gasket of new
cartridge filter (2).
3. Turn cartridge filter (2) clockwise by hand until the
gasket touches the contact area.
4. Using the filter wrench, tighten the cartridge 3/4 turn
more.
Be careful not to overly tighten cartridge filter (1).
Deformation of the cartridge may result.
5. Bleed Air from the Fuel System
After replacing the fuel pre-filter, bleed air from the fuel
system.
(Refer to "Bleed Air from the Fuel System" in item
MAINTENANCE
.)
2
7-64
1
MNDB-07-002
M4GB-07-066

Advertisement

Table of Contents
loading

This manual is also suitable for:

70tm7

Table of Contents