Table of Contents
Advertisement
Quick Power Switch
By pressing quick power switch (1) when the power mode is
OFF, the power mode is temporarily activated. (The power
mode indicator (2) lights ON.)
NOTE: The quick power switch is operable only in the
following cases.
An added push is needed during digging (tractive)
operation.
Need a little more acceleration or travel speed while
ascending on a slope.
When operating under low load or the forward/reverse lever
is in "Neutral" (N) position, the mode will not change to power
mode even if quick power mode switch is pressed. The switch
selection is ruled invalid.
Also, even if the machine is in the power mode, it is canceled
when the following conditions are met.
When operating load is decreased while digging.
When the quick power mode switch is pressed.
The forward/reverse lever or forward/reverse switch is
shifted.
While driving in the auto-shift mode, the gear shifts up to
the selected gear stage.
OPERATOR'S STATION
1-76
1
1
MNEC-01-042
70MNDB-01-05
MNDB-01-008
2
Advertisement
Table of Contents
