Table of Contents
Advertisement
Lifting Machine
WARNING:
The lifting tools are optional. Install specified lifting
tools at your nearest authorized dealer.
Use lifting cables and other lifting tools that are free
from any damage and/or aging, and properly rated
for the load.
Consult your nearest authorized dealer for correct
lifting procedures, and size and types of lifting cable
and tools.
Before lifting the machine, move the control lever
lock switch to the LOCK ( ) position to prevent the
machine from moving unexpectedly.
Rigidly secure the front and rear chassis using the
articulation lock bar so that the machine front and
rear chassis will not steer.
Incorrect lifting procedure and/or incorrect wire
cables may cause the machine to move (shift) while
being lifted, resulting in machine damage and/or
injury of personnel.
Do not lift the machine quickly. Excessive load will
be applied to the wire cables and/or lifting tools, and
may cause them to break.
Do not allow anyone to come close to or under the
raised machine.
Lifting
1. Straighten the machine and lower the front attachment
as illustrated to the right.
2. Move the control lever lock switch in the LOCK ( )
position.
3. Rigidly secure the front and rear chassis using the
articulation lock bar.
4. Stop the engine. Remove the key from the key switch.
5. Use cables long enough so that the cables do not come
in contact with the machine chassis when the machine is
lifted.
Wrap some protectors around wire ropes and/or support
bar as required to prevent the sheet metal from being
damaged. Be sure to use the specified lifting tools.
6. Set the crane in an appropriate position on a firm, level
surface.
7. Attach the cable to the lifting tools.
8. Load machine slowly and carefully, as desired.
TRANSPORTING
6-10
MNEC-05-001
Advertisement
Table of Contents
