Table of Contents
Advertisement
Driving the Machine
Correct operation will result in extending the service life of
each part and component as well as saving fuel and oil. Always
be sure to safely and efficiently operate the machine while
paying attention to the following points.
IMPORTANT: The engine must be started and ready for
driving correctly by referring to the previous section
"OPERATING THE ENGINE".
Precautions for starting to move
1. Perform a thorough walk-around inspection. Conduct
correct start-up procedure.
2. After raising the lift arm, set the lift arms and bucket in
the operating position.
3. Before driving on public roads, set the machine to the
driving position as illustrated to the right. Be sure to
press LOCK ( ) side of control lever lock switch (1) so
that the linkage will not move even if the control levers
are accidentally moved.
Linkage for Traveling on Public Roads in Italy (70TM7)
Fix the linkage during traveling on public roads in Italy.
Install the lock bar (1) on the both side of lift arm (2) to prevent
the bucket (3) fall.
MOVING THE MACHINE
A
Linkage
4-1
Position
A: 300 mm (1 ft)
Linkage
Traveling posture
3
2
MNEC-04-001
1
MNEC-07-001
M4GB-07-183
1
M4GB-07-182
Advertisement
Table of Contents
