Parameter Menu (Para) - DEMAG DIC 002 Series Operating Instructions Manual

7.3.3

Parameter menu (PARA)

A
Fig. 34 Parameter menu (PARA)
The parameters that are polled during guided set-up have been selected from existing applications and should be
supplemented by further settings in the PARA sub-menu, if required. The quick-step operating instructions de‐
scribe the basic parameters and the basic functions of the software.
A Use the ▲ ▼ keys to select the required number from the parameters shown in numerical order. The parameter number is shown flashing with the
active data set in the display.
Keys
▲
▼
▲ + ▼
FUN , ▲
FUN , ▼
B Press the key to select the parameter which is displayed with the current parameter value, unit and active data set.
ENT
C The parameter value can be modified using the ▲ ▼ keys. Depending on the parameter, the value must be changed or an Operation Mode must
be selected.
Keys
▲
▼
▲ + ▼
FUN , ▲
FUN , ▼
FUN , ENT
D Press the key to save the parameter value. The SEt message is displayed briefly with the parameter number and data set. Press the
ENT
key to quit the parameter without making any changes.
Messages
Err1: EEPrO
Err2: StOP
Err3: Error
E Once the parameter has been saved, you can change the value again or press the
Tab. 52
ENT
B
Select parameters
Switch to the last modified parameter
Display last parameter (highest number)
Display first parameter (smallest number)
Modifies the parameter value
Sets the parameter to the default setting
Sets the parameter to the highest value
Sets the parameter to the smallest value
Changes the data set for switchable parameters
Parameter could not be saved
Parameter can only be read during operation
Other error
ESC
E
C
key to switch to parameter selection.
ESC
ENT
D
ESC
42395444_xml.eps
ESC
55