Actual Value Menu (Val) - DEMAG DIC 002 Series Operating Instructions Manual

7.3.2

Actual value menu (VAL)

A
Fig. 33 Actual value menu (VAL)
In the VAL sub-menu, the keypad unit displays many actual values depending on the configuration selected and
on the hardware modules that are installed. The quick-step operating instructions document a selection of param‐
eters and the basic functions of the software.
A Use the ▲ ▼ keys to select the required number from the actual values shown in numerical order. The number is shown flashing with the active
data set in the display.
Keys
▲
▼
▲ + ▼
FUN , ▲
FUN , ▼
B Press the
ENT
C Every actual value parameter can be monitored in detail when the unit is put into service, during operation and for fault analysis.
Keys
▲
▼
FUN , ▲
FUN , ▼
FUN , ENT
D Press the
ENT
appears for a short time. This actual value will be automatically displayed when the frequency inverter is switched on in future.
E You can monitor and display the value again when the parameter has been saved. Press the
the VAL sub-menu.
Tab. 51
54
ENT
B
Select parameters
Change to the actual value parameter when switching on
Display last actual value parameter (highest number)
Display first actual value parameter (smallest number)
key to select the actual value which is displayed with the current parameter value, unit and active data set.
Change data set when actual values can be changed
Maximum actual value is continuously determined and displayed while ▲ is pressed
Minimum actual value is continuously determined and displayed while ▼ is pressed
Average actual value during the monitoring period while
key to save the selected actual value as a parameter when the unit is switched on. The SEt message with the parameter number
ESC
E
C
is pressed
ENT
key to enter the parameter selection section of
ESC
ENT
D
ESC
42395344_xml.eps