Section 9 - Can-Bus Connection; Can-Bus Connection - Miller Trailblazer 330 Diesel Owner's Manual

SECTION 9 – CAN-BUS CONNECTION
9-1.

CAN-Bus Connection

1 CAN-Bus Connector
A CAN-bus connection is provided to allow
read-only data communication. The data is
available through the CAN-bus connector lo-
cated inside left-hand access door, on the
main harness. Data is transmitted when the
unit is On. The CAN port is transmit only.
Pin Description
1 Ground
2 CAN High
3 CAN Low
4 Cable Shield
5 +12 VDC
6 (Open)
2 Wedge Lock (Supplied) (Deutsch W65-
P012)
3 CAN Plug (Supplied) (Deutsch DT06-6S-
P012)
4 Terminal (Not Supplied) (Deutsch 1062-
16-0122)
5 Cabling (Customer Supplied)
6 CAN BUS Receptacle
Remove connector plug from receptacle.
Disassemble plug and remove seals as
needed.
Insert insulated wires (16 or 18 AWG) using
Deutsch 1062-16-0122 terminals.
Reassemble connector and reconnect to
CAN BUS receptacle.
OM-291102 Page 57