Updating Software - Miller Trailblazer 330 Diesel Owner's Manual

6-19. Updating Software

Preparing For Software Update
Step 1. Verify current software version installed.
Step 2. Press Settings button and use Adjust Control/Select button to select System Info.
The current software revision is displayed.
Step 3. Verify that USB thumb drive is good by inserting it into USB receptacle on bottom of remote panel. Press "Download Service File"
from menu.
Status bar should read "USB Write Successful", indicating a good USB flash drive.
Downloading Software
�
Use a PC to download software. Do not use a Mac.
Step 4. Locate latest firmware to be loaded from
Step 5. Click to download file. When the download is complete, run it.
Step 6. Accept software licensing agreement.
Step 7. Copy desired firmware to an empty USB thumb drive.
�
Files must be at the top level of the USB and not zipped or inside a folder.
Installing Software
Step 8. Turn Off welder/generator.
Step 9. Insert thumb drive into USB receptacle on front of machine.
Step 10. Turn Engine Control switch to Run or Run/Idle position.
�
Do not start engine.
Display will change to System Info screen.
Step 11. Use Adjust Control/Select button to select Firmware Update.
Display will ask to confirm if you would like to update software.
Step 12. Confirm to update software.
�
After update has started, do not power down unit or remove thumb drive until update is complete.
During download, the progress bar displays current file being updated on bottom with name of file being downloaded.
Each file being updated will progress from 0 to 100 on progress bar. Software updates may take several minutes.
Failures are indicated on status bar on top of display. Correction of failed updates depends on what type of failure occurred.
When update has completed, a prompt will read: SOFTWARE UPDATE COMPLETE
Step 13. Press Back button to go back to System Info screen.
Current software revision is displayed.
Step 14. Verify new software revision has installed.
OM-291102 Page 48
MillerWelds.com