Setting Battery Charge Controls - Miller Trailblazer 330 Diesel Owner's Manual

7-4.

Setting Battery Charge Controls

3
4 1
For batteries that do not take a charge current:
Some batteries may not take a charge current, no matter what the voltage of the battery is.
Under these conditions, the unit control system will allow a battery to charge or jump start for
40 seconds. Then, if the battery still does not take a charge, the output will turn off. Reset the
system to try again. The voltage on the battery must stay above 1volt when the charging
clamps are attached, or the control system will not start charging.
A. Check Battery
Batt Charge Voltage Error
Batt Read Open Error
Batt Check Open Error
Batt Charge Polarity Error
B. Over Voltage
Batt Charge Over Voltage Error
C. Jump Timeout
Batt Jump Start Timeout Error
D. Battery Bad
Batt Charge Check Error
Batt Charging Bad Battery Error
Batt Final Check Error
Batt Final Check Battery Error
E. Charge Complete
Battery Charge Complete
Codes indicate the battery will not accept a charge, battery voltage does not match charging voltage,
or the system is improperly connected.
Check battery and connections.
Cycle Charge/Stop selections to restart charging.
Code indicates the battery is accepting too much voltage or no current.
Reset clamp connection to clear.
Code indicates the system was drawing too much current for too long of a time during an attempt to
jump start.
Cycle Charge/Stop selections to restart charging.
The charger has determined that the battery is faulty and is unable to take a charge.
Replace the battery.
The battery charge process has completed successfully.
To start charging a battery:
� Select either 12 V or 24 V with the con-
trol/select button depending on the type
of battery being charged.
� Connect the battery terminals as de-
scribed in Section 7-2 and 7-3.
� Push the Charge button.
� When finished charging push the Stop
button.
� Disconnect the battery cables.
1 Charge Button
Press the Charge button to start battery
charge.
2 Stop Button
Press the Stop button to stop battery charge.
3 12 V or 24 V Selection
Status bar text provides information on
charge mode, charging output and charging
2
status. Explanations of the status bar mes-
sages are provided in the table below.
4 Home Button
Press the Home button to go back to the
Home screen.
OM-291102 Page 51