Section 4 - Specifications; Serial Number And Rating Label Location; Software Licensing Agreement; Information About Default Weld Parameters And Settings - Miller Trailblazer 330 Diesel Owner's Manual

4-1.

Serial Number And Rating Label Location

The serial number and rating information for this product is located on the rear panel. Use rating label to determine rated output. For future refer-
ence, write serial number in space provided on back cover of this manual.
4-2.

Software Licensing Agreement

The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula
4-3.

Information About Default Weld Parameters And Settings

NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
4-4.

Weld, Power, And Engine Specifications

�
This equipment will deliver rated output at an ambient air temperature up to 104°F (40°C).
Rated
Welding
Welding
Output
Mode
100% Duty
Cycle
314 A, 32.5 V*
CC/DC
330 A, 31 V
CV/DC 330 A, 30.5 V*
* Meets NEMA and IEC Ratings
4-5.

Optional Battery Charger Specifications

Output
Battery Charge
Jump Start
4-6.

Environmental Specifications

A. IP Rating
This equipment is designed for outdoor use. It may be stored, but is not intended to be used for welding outside during precipitation unless
B. Temperature Specifications
Operating Temperature Range*
-20 to 104°F (-29 to 40°C)
*Output is derated at temperatures above 104°F (40°C).
C. Information On Electromagnetic Compatibility (EMC)
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public
low-voltage supply system. There can be potential difficulties in ensuring electromagnetic compatibility in those locations,
due to conducted as well as radiated disturbances.
�
Complete Parts List is available at www.MillerWelds.com
SECTION 4 – SPECIFICATIONS
and are incorporated by reference herein.
Maximum Weld
Open-Circuit Output
Voltage Range
107 20 – 330 A
107 15 – 40 V
Rated Output
5 to 150 A, 12 V Charge
5 to 150 A, 24 V Charge
300 A, 12 V Jump Start for 20
Seconds
300 A, 24 V Jump Start for 20
Seconds
Fuel
Generator
Capaci-
Power Rating
ty
Peak: 12kW
Continuous:
D902–E4B-MLR-3
10.5 kVA/kW, 11 gal
18.5kW@3600 rpm
88/44 A, (42 L)
120/240 V AC, Tank
60 Hz,
Four-Cycle Diesel
Single-Phase
Output Range
12 or 24 V
IP Rating
IP23S
sheltered.
Storage/Transportation Temperature Range
-40 to 131°F (-40 to 55°C)
Engine Fuel Type
Kubota
Ultra Low Sulfur Diesel
�
See Engine Owners
Water-Cooled,
Manual for biodiesel
Three Cylinder,
use.
Maximum Open-Circuit Voltage
(Nominal)
14/28
OM-291102 Page 17