Section 5 - Installation; Installing Welder/Generator - Miller Trailblazer 330 Diesel Owner's Manual

1-1. Installing Welder/Generator

1-1. Installing Welder/Generator
5-1. Installing Welder/Generator
Movement
Location/Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
18 in
18 in
(460 mm)
(460 mm)
24 in
18 in
(610 mm)
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
Mounting
�
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – INSTALLATION
18 in
(460 mm)
24 in
18 in
(610 mm)
(460 mm)
18 in
(460 mm)
24 in
18 in
(610 mm)
(460 mm)
1
1
Do not move or operate unit where
it could tip.
Do not lift unit from end.
Do not weld on base. Welding on
base can cause fuel tank fire or ex-
plosion. Bolt unit down using
holes provided in base.
Always securely fasten welding
generator onto transport vehicle or
trailer and comply with all DOT and
other applicable codes.
NOTICE – Do not install unit where airflow is
restricted or engine may overheat.
�
See Specifications for lifting eye rating.
Mounting:
Do not mount unit by supporting
the base only at the four mounting
holes. Do not use flexible mounts.
Use cross-supports to adequately
support unit and prevent damage
to base.
1 Cross-Supports
Mount unit on flat surface or use cross-sup-
ports to support base.
�
Go to MillerWelds. com for more infor-
mation on truck installations.
OM-4410 Page 1
OM-291102 Page 25