EXFO AXS-200 User Manual page 16

Using the Loss Certification Wizard
10. If necessary, perform a reference
measurement by pressing
11. Press
arrows to select the number of
reference jumpers used for
referencing and press
12. Connect the units as shown on
screen (for more details you can
see Referencing Your Power Meter
to a Source on page 21).
13. Press Next.
14. Press
arrows to select the wavelength
for which you want to set a
reference, and press
15. Press Set Reference.
16. Repeat steps 14 and 15 to set a
reference for other wavelengths.
17. Press Next.
18. Enter the cable name and then the
fiber identification parameters (for
more information see Setting
Autonaming Scheme on page 28).
19. Press Next.
8
and use the up/down
again.
and use the up/down
again.
.
AXS-200/350 and AXS-200/360