Table of Contents
Advertisement
10.9.4 RM – Residual Maintenance Cycles, number of cycles remaining before maintenance –
Counter
Cycles remaining before maintenance.
Indicates, to the nearest ten, the number of cycles
remaining before routine maintenance (e.g. "RM-
90" on the display indicates that there are 900 cycles
left before the maintenance warning).
When Zero is reached: the code changes from RM
(Residual Maintenance cycles) to RMW: (Residual
Maintenance Warning).
The numerical value which follows (e.g. RMW:01)
corresponds to the tens of cycles performed after
zero was reached (e.g. 910).
Progression of values
RM-90 (900 cycles remaining), RM-89 (from 899 to
890 cycles remaining) ... , RM-00 (from 9 cycles
remaining to 0),
RMW:01 (from 1 to 9 cycles after zero), RMW:02 etc.
up to RMW:99 (after which the counter stops).
The value can be reset by a Smeg authorised
engineer: hold down P5.
The initial value of RM-90 is restored and the
countdown restarts.
10.10
PRINT – Ristampa ultimo ciclo e parametri macchina
PRINT: menu accessible when the printer is
installed and enabled, to force reprinting of the
last cycle performed (e.g. after the paper is
replaced) and to print the machine parameters
which characterise the device.
There are two options on the second line of the
display:
-
LAST: Last Cycle, to print the last cycle.
-
PARAM: printout of machine
parameters.
Button P5 is used to confirm printing of the
individual option. The R and L buttons are used
to switch between the two options.
[During printing and until it is completed: the
buttons are disabled].
User Manual
193909105 rev.04
...
BPW1260 – BPW4260
Page 70 – 107
Advertisement
Table of Contents
