Table of Contents
Advertisement
16.2
WATER DRAIN REQUIREMENTS
WARNING
The drain must comply with international regulations: the manufacturer accepts no liability for pollution
caused by misuse of the device.
The
water
It must be managed and treated in accordance with the regulations in force in the country of installation.
Notes:
make sure to use a drain with trap. When installing the drain connection, take the following
precautions:
• The difference in height between the end of the drain hose and the surface on which the device is
installed must comply with the stated specifications.
• The internal diameter of the drain pipe must be no less than 110 mm.
• Use of a drain pipe of 110 mm diameter is recommended.
•
No extensions must be added to the drain hose supplied with the device. Any extensions may case
problems of flowback into the chamber.
17 AFTER-SALES SERVICE AND MANUFACTURER CONTACT DETAILS
Smeg S.p.A.
Via Leonardo da Vinci, 4
42016 Guastalla – Reggio Emilia – Italy
www.smeg-instruments.com
Italy
After-Sales Service (Service and Technical Information) contact:
•
Single contact number for Italy +39 0522.160.60.50
o
Email:
o
For sales information:
•
Email:
o
International Customers
Please contact your Local Smeg Distributor or write an email to
User Manual
drain
may
assistenza.instruments@smeg.it
instruments@smeg.it
193909105 rev.04
contain
biological
service.instruments@smeg.it
BPW1260 – BPW4260
contaminated
materials.
Page 107 – 107
Advertisement
Table of Contents
