Alarm Table - Smeg BPW4260 User Manual

13.2.1 ALARM TABLE

ID DESCRIPTION
Water in steam generator not
AF:01
heated within time allowed.
The temperature
between the two chamber
AF:02
probes, "TL" and "TCL", is more
than the set threshold.
The A value is not reached
0
AF:03 within the allowed time on the
basis of the target temperature.
The temperature reading of the
"TG" (generator temperature)
AF:04
probe is higher than the set
value.
Operating temperature probe
AF:05 "TL1" has
anomalous signal.
Generator temperature probe
AF:07 "TG" has
anomalous signal.
Control temperature probe TCL
AF:10 has generated an anomalous
signal.
No cold water during intake
AF:11
phase.
No hot water during intake
AF:12
phase.
Water intake time not correct.
AF:17 The device is taking too long to
draw water into the tank.
AF:23 Tank water level drops too low
Anomaly in opening of washing
AF:25
solenoid valves
AF:27 Tank does not empty.
User Manual
difference
User: follow the DEFAULT PROCEDURE described above. If
the alarm does not disappear, follow the RESET
PROCEDURE.
In standby status, the alarm resets automatically if its
causes are eliminated.
generated an
generated an
Check the water supply:
1. Check that the water intake taps are turned on.
2. Check the water supply pressure.
Check the position of the intake hoses.
1. Check that the intake tap is turned on.
2. Check the water supply pressure.
3. Check that there are no restrictions in the hose
connecting the device to the tap.
4. Check that the filters upstream of the intake hoses are
not fouled.
Run the checks and procedures specified for AF:11.
Also check that there no leaks from the device (no water
around it).
If there are leaks: turn off all water supply taps at once and
contact the after-sales service.
User: follow the DEFAULT PROCEDURE described above. If
the alarm does not disappear, follow the RESET
PROCEDURE.
In standby status, the alarm resets automatically if its
causes are eliminated.
193909105 rev.04
USER ACTION
BPW1260 – BPW4260 Page 85 – 107