Table of Contents
Advertisement
7. Camera Installation Instructions
7.1. Wiring Installation
A.
Run a Cat5e/6 cable from the network port to the camera location and terminate both
ends to 568B.
B.
(Non-PoE applications) Run wiring to the camera from the power supply location. Use
the voltage drop calculator at
C. (Non-PoE applications) Connect the power supply to the wire at the head end using
electrical connectors (not included), and attach the WPS-ACC-PWR-M to the wire at
the camera location. Be sure to use the correct polarity.
D. (Non-PoE applications) Connect the power supply to a suitable outlet and test the
voltage at the camera side of the wire using a volt meter. Disconnect the power supply
from the outlet until camera installation is otherwise complete.
7.2. Prepare for Installation
A.
Unpack the camera and locate the hardware and 3mm Allen wrench.
B.
Depending on the mounting location, it may be easier to position the correct field-of-
view before installation. See step 7.4 "Aiming the Camera" adjustment instructions.
7.3. Mount the Camera
7.3.1.
Using Mounting Accessories
A.
Mount the accessory according to its instructions.
B.
Make wiring connections, mount the camera, and then continue to 7.4 "Aiming the
Camera" below.
7.3.2.
Surface Mounting
A.
Use the camera mounting base as a template to mark the location of the 3 screws on
the mounting surface.
B.
Connect the camera to the wiring and move it into position. Avoid pinching the wires
between the camera and the mounting surface.
C. Use 3 of the included screws to secure the camera. Hand-tighten the screws evenly.
7.4. Aiming the Camera
A.
Use the 3mm Allen wrench to loosen and tighten each adjustment screw:
•
Horizontal rotation (A)
•
Swivel left or right (B)
•
Tilt viewing angle (C)
© 2014 Wirepath Surveillance
www.SnapAV.com
to determine the wire size needed.
WPS-300-BUL-IP Installation Manual
A
B
C
11
Advertisement
Table of Contents
