Table of Contents
Advertisement
WPS-300-BUL-IP Installation Manual
7.5. Network Software Setup - IP Installer
The IP Installer software included with the camera provides a quick view of Wirepath™ IP Surveillance devices connected to the
local network. Use the Installer to search for and set basic IP settings for each camera.
Before starting any configuration or service of Wirepath™ IP devices, we recommend checking for a newer version of the IP
Installer on the camera's support tab at www.SnapAV.com.
Important! Active VPN connections anywhere on the network will prevent the IP Installer from working correctly. Close all
VPN connections before running the Installer.
"Device List" displays
connected devices on
the network.
Click a device name to
make changes in the
right column.
Double-click a device
name to load the
interface in your web
browser.
Click "Search Device"
to refresh the Device
List.
7.5.1. Running the IP Installer
A.
The IP Installer EXE file can be downloaded from the camera's support tab at www.SnapAV.com. No installation is required for
use. Extract the file from the ZIP file (if compressed) and move it to the Desktop or folder of your choice.
B.
Right-click and select "Run as Administrator" to open the software.
Important! Windows may interrupt and warn against running the IP Installer. Allow the software to run. No changes will be
made to Windows or other system files.
C. When the installer opens, it automatically scans the network for any connected Wirepath™ IP Cameras, NVRs, and Encoders.
Click "Search Devices" to scan the network and refresh the list with new devices.
D. Click the "X" at the top right corner or the "Exit" button to close the IP installer when all devices are configured. Windows may
display an error that the software did not install correctly when it closes but this should be disregarded.
12
The right column shows
current IP settings for
the highlighted device.
Change settings by
updating the fields and
then clicking "Submit".
Advertisement
Table of Contents
