8- Camera Installation; 1-Prepare Camera For Mounting; 2-Connect The Camera To The System - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

8- Camera Installation

1- Prepare Camera for Mounting
Prior to mounting to the Camera, we recommend that the position and angles be preset in order to reduce configuration time.
These settings can be fine-tuned once the Camera is mounted.
A. Adjust Camera Rotation
B. Adjust Swivel of Camera
C. Adjust Camera Angle
2- Connect The Camera to the System
Recommended Cabling
Ethernet
DC Power
Audio In/Out
POE Consumption
A. Connect the Ethernet connection to a Cat5e/Cat6 cable using the provided RJ45 female/female adapter. The opposite
end of the Cat5e/Cat6 will be connected to the network switch.
B. Connect the DC Power In to a 12V DC 1A power supply using the included WPS-ACC-PWR DC power adapter. If using
PoE to power the Camera, this step can be omitted.
Tip: The power supply can be located at the head end of system using a WPS-PS multiple output power supply and
prewiring a power wire.
C. Connect the Audio Out of a WPS-ACC-MIC to the Audio In jack of the Camera using an RCA Male to 3.5mm mono male
adapter. If no microphone will be used, this step can be omitted.
Note: The WPS-ACC-MIC requires power, if PoE is being used, a power supply for the microphone will need to be
installed.
D. Connect the Audio Out (Green) on the Camera pigtail to a 3.5mm mono male plug. This will be connected using 16/2 to
an amplifier for playback of the microphone. If no audio output is being used, this step can be omitted.
E. Connect an Alarm output or input to the connecting block. If no alarm functions are being used, this step can be
omitted.
www.snapav.com Support: 866.838.5052
Cat5e/Cat6
16/2 (if using a remote power source other than a PoE switch)
16/2
PoE IEEE 802.3af
3.84W(IR Off) / 7.56W(IR On)
B
C
A
WPS-750-BUL-IP Installation Manual
Pg. 15