Table of Contents
Advertisement
WPS-750-DOM-AH Installation Manual
INSTALLATION
1. Prepare Camera for Mounting
Prior to mounting to the Camera, we recommend that the position
and angles be preset in order to speed installation. These settings
can be fine-tuned once the Camera is mounted.
Important Note: To avoid damaging the dome surface during installation, keep the
dome surface away from walls and other objects. Do not remove the protective
coating from the dome until after the camera is mounted and the dome installed.
Microfiber or similar cloths can be abrasive, only use a dry eyeglasses cloth when
cleaning he lens to avoid damage that can blur the cameras image.
A. Open the camera by using
the provided 3mm Allen key to
remove the three screws on the
dome cover.
B. Pre-adjust the camera's 3-axis
angle so the lens points in the
desired direction. The lens angle
should not exceed 50˚ off the
center axis.
2. Connect The Camera to the System
Recommended Cabling
Video
RS485 OSD Control
Power
A. Connect the BNC video output to the video in
of a DVR or monitor.
B. Connect the DC Power In to a power supply
using the included WPS-ACC-PWR power adapter. The power
supply can be located at the head end of system using a WPS-PS
multiple output power supply and prewiring a power wire.
Important Note! Be sure to use the correct power supply and power wire for the
length of run to the camera to ensure reliable operation. Too small a power supply
or wire will cause too much voltage drop, which will cause the camera to operate
incorrectly or not power up at all.
C. The RS485 leads to a WPS-CCTV-TESTER, DVR, or PTZ controller to
view, and control the OSD menu.
8
RG59 or RG6
Cat5e/6
18/2 or Cat5e/6
12V DC
BNC
RS485 Leads
Power In
Video Out
Advertisement
Table of Contents
