Configuring Motion Detection Areas; Motion Detection Settings Overview - Wirepath Surveillance WPS-300-BUL-IP Installation Manual

WPS-300-BUL-IP Installation Manual

9.5.2. Configuring Motion Detection Areas

Motion detection allows for specific areas of the image to be used for triggering the recording of video, an alarm, or sending a
notification. When an area is defined, motion in that area will trigger the predefined action; this is useful to avoid unwanted events
from being triggered due to motion in areas of no concern.
9.5.2.1.

Motion Detection Settings Overview

Area Setting Area Setting Select the button to set the area for detection.
Adjustable from 1 (Requires higher amount of motion to trigger) to 10 (Requires low amount of motion
Sensitivity
to trigger).
•
•
Area 1, 2, 3 •
•
Subject Text to use as subject of email notifications when they are sent.
Selects the minimum time between motion events that the camera will respond to. Higher values are
Interval
useful to reduce notifications for camera scenes with more expected motion.
Only in
Schedule When selected, motion events will only be triggered based on a configured schedule.
Times
Click "Apply" at the bottom-right of the page to save modified settings.
50
Area # - When selected the area is enabled allowing for the events defined below to occur.
E-Mail - check the box to send media via email. Requires configuration of Email Settings as
defined in section 9.3.8.2. Mail
FTP - check the box to save media to an FTP site or server. Requires configuration of FTP as
defined in section 9.3.8.3. FTP
Network Share – check the box to save media to a Network Share location. Requires the
configuration of Network Share as defined in section
Settings.
Settings.
9.3.8.4. Network Share Settings