Table of Contents
Advertisement
Basic IP Settings, Continued
9.3.1.5.
Multicast Setting (Based on RTSP Server)
Multicasting delivers a single stream to multiple network recipients simultaneously. All packets are copied identically to each
recipient to save bandwidth. When using Multicast, be sure to enable the function "Force Multicast RTP via RTSP" in your media
player, then key in the RTSP path of your camera: "rtsp://(IP address)/" to receive the multicast stream. Configuration is not required
for normal camera operation. This is an advanced feature that is used for access by some third-party interfaces.
5
Streaming 1
Streaming 2
Click "Apply" at the bottom-right of the page to save modified settings.
9.3.1.6.
ONVIF
The ONVIF (Open Network Video Interface Forum) standard is used by IP surveillance for communication across devices from
various manufacturers. This setting does not require configuration when being used with Wirepath™ IP surveillance devices
ONVIF
6
Security
RTSP
Keepalive
Click "Apply" at the bottom-right of the page to save modified settings.
9.3.1.7.
Bonjour
Enabling this setting allows for the Camera to be accessed by Mac computers as a Bonjour device.
Bonjour
7
Bonjour
Name
Click "Apply" at the bottom-right of the page to save modified settings.
9.3.1.8.
Link Layer Topological Discovery (LLTD)
LLTD is a proprietary Microsoft technology that displays camera connection status and properties in a PCs network map. LLTD
uses Media Access Control (MAC) addresses, not IP addresses. The PC must support LLTD and have it enabled in order to use
this feature.
8
LLTD
Click "Apply" at the bottom-right of the page to save modified settings.
© 2014 Wirepath Surveillance
Streaming output 1 settings
IP Address
Enter an adress for accessing the Multicast stream. (224.3.1.0 - 239.255.255.255)
Port
Enter the port used for Multicast communication. (1 - 65535)
Determines the number of users that can receive the stream simultaneously. Set
TTL
to a higher value to allow more users. (1 - 255)
Streaming output 2 settings
IP Address
Enter an adress for accessing the Multicast stream. (224.3.1.0 - 239.255.255.255)
Port
Enter the port used for Multicast communication. (1 - 65535)
Determines the number of users that can receive the stream simultaneously. Set
TTL
to a higher value to allow more users. (1 - 255)
Select the desired ONVIF standard to be used in the camera, or disable the feature.
Enable or disable ONVIF security.
Enable or disable RTSP Keepalive. Enable if ONVIF is being used and RTSP has been configured to
ensure that the connection is kept alive.
Enable or disable Bonjour discoverability.
(If Bonjour is enabled) Select the custom name to be displayed in Bonjour.
Enable or disable LLTD
WPS-300-BUL-IP Installation Manual
29
Advertisement
Table of Contents
