Table of Contents
Advertisement
9.5.2.2.
Adding a New Motion Detection Area
A.
Select Event Setting under Event on the left side Menu.
B.
Select the Area for Motion Detection.
C. Select Area 1 next to the blue box.
D. Place the mouse at the upper left hand corner of the area to mask, hold down the left mouse button and drag the box over the
area to mask and release the mouse button.
E.
Select the Sensitivity level in the drop down box under the Area. (Range 1 Low to 10 High).
F.
Select the check box next to the area and select the type of Events to perform when motion is detected in that area.
G. Select a Name to use for the Subject line of email notifications.
H. Set the Interval between motion events (the minimum time to wait before triggering subsequent motion events).
I.
Repeat Steps A-H for Areas 2 & 3 if more areas are needed.
J.
Set the Delivery Media Format.
K.
Select the File Format from the dropdown list.
L.
Select the time to Start and Stop the recording.
M. Select Action to Perform when Connection is Lost.
N. Select Apply at the bottom of the screen to save the settings.
9.5.2.3.
Removing a Motion Detection Area
A.
Select the button for the area to remove. The colored grid for the selected area will be removed.
B.
Click "Save" to save the change.
© 2014 Wirepath Surveillance
WPS-300-BUL-IP Installation Manual
51
Advertisement
Table of Contents
