Table of Contents
Advertisement
WPS-765-DOM-AH Installation Manual
4. Installation Instructions
Wiring must be installed before the camera. See the previous page for
connections and wiring recommendations.
Step 1. Prepare for Installation
Important! DO NOT remove the protective plastic film from the camera
dome until installation is complete and the camera is being sealed for
the last time.
A. Unpack the camera and locate the included foam gasket, hardware,
mounting template, silica packet, and 3mm Allen wrench. If a mounting
accessory is being used, unpack the accessory and become familiar with its
installation and use.
B. Apply the self-adhesive foam gasket to the base
of the camera.
C. If the camera will be connected using the 3/4"
conduit side entrance, remove the threaded plug
and route the wiring pigtail through the opening.
D. Use the 3mm Allen wrench to open the camera.
E. Review the lens angle-of-view limits and make sure
the camera location will allow it be aimed toward
the desired field of view.
The setscrews for the gimbal should be factory preset to allow
adjustment without binding, but may be adjusted as needed
using a #1 or #2 Phillips screwdriver.
8
Maximum Camera Angle
67.0°
67.0°
Advertisement
Table of Contents
