Administrator Account Setup; Add, Edit, Or Remove A Guest Account - Wirepath Surveillance WPS-300-BUL-IP Installation Manual

Ip bullet camera

Hide thumbs Also See for WPS-300-BUL-IP:

Table of Contents

9.2.3.5.

Administrator Account Setup

The administrator password should be changed during setup to prevent unwanted access. Select a new password up to ten

characters in length made up of letters and numbers (no punctuation or symbols).

Click the "Edit" button next to the username "admin" in the User List to open the User Setup window.

Change the Administrator username and enter a new password, or re-enter the existing password in each password field, then

click "Okay" to save the changes.

C. After selecting OK, the camera will automatically log out. Enter the new log-in information in the pop-up and sign back into the

camera as normal to continue setup. Be sure to record the Administrator account information in a safe place. If administrator

account access is lost, a manual reset of the camera is required.

9.2.3.6.

To create a new guest account, enter the desired username and password in the fields as indicated on the previous page in section

9.2.3.2. Add User (Guest Account

After a guest account has been created, the password may be changed by clicking the "Edit" button in the User List. To change the

username, a new account must be created and the old one removed.

only), and then click the "Add" button to add the new user.

WPS-300-BUL-IP Installation Manual

Table of Contents