Camera A/V Settings; Image Settings Menu - Wirepath Surveillance WPS-300-BUL-IP Installation Manual

9.4. Camera A/V Settings

9.4.1. Image Settings Menu

The image setting menu is used to set up the camera view for the best image possible. Brief descriptions of the menu are given
below. Complete instructions for setup are in the following sections.
• Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "Image
Settings" in the left column menu.
1
Privacy Mask
Image Setting
2
Brightness
Contrast
Hue
Saturation
Sharpness
AGC
Shutter Time
Sense-Up
D-WDR
Anti-Fog
Lens
Distortion
Correction
Video
Orientation
Red/Blue Gain Set the red and blue balance from -5 (Low) to 5 (High). Default: 0.
Digital Noise
Reduction
Default
Day and
3
Night Setting
© 2014 Wirepath Surveillance
1
2
3
See section 9.4.2.4. How to Configure Privacy Masks
Adjust overall brightness from -4 (Low) to +4 (High). Default: zero (0).
Adjust white levels from -4 (Low) to +4 (High). Default: zero (0).
Adjust the color tone (or tint) between -4 (Blue) and +4 (Red). Default: zero (0).
Adjust color intensity from -4 (Low) to +4 (High). Default: zero (0).
Adjust edge detail from -4 (Low) to +4 (High). Default: zero (0).
Auto Gain Control balances high contrast scenes. Adjust from 16x (Low) to 64x (High). Default: 16x.
Use automatic Indoor or Outdoor preset modes or set 1/30(Slow)-1/1000 (Fast). Default: Outdoor.
Set slow shutter time for use in low light areas from 1/15 or 1/30. Default: 1/15.
Digital Wide Dynamic Range balances dark and bright areas in low light scenes to maintain high image
quality. Turn on and set from 1 (Low) to 8 (High). Default: Off.
Check Enable to clear foggy scenes using software, Default: Off.
Adjust the image so that curvature image distortion caused by the lens is reduced to a minimum. Turn
on and set from 1 (Low) to 8 (High). Default: Off.
Check the box for Flip or Mirror to change the image appearance. Both settings are disabled by default.
3D - Reduces noise around moving objects. Default: 5.
2D - Reduces noise around stationary objects. Default: 1.
Click to reset all Image Setting menu values.
See section 9.4.2. How to Configure Day and Night Settings (Color Modes)
WPS-300-BUL-IP Installation Manual
41