Table of Contents
Advertisement
9.3.7.4.
Setting Up a DDNS Address – WirepathDNS
A.
To use Wirepath DDNS service, enable the DDNS feature by selecting the button.
B.
Enter a prefix for the address in the host name field as shown in the example above (system1).
C. Click "Apply" in the bottom-right corner to save the address. After a moment, the page will reload and the address will appear in
the "State" box as shown below:
D. DDNS is now correctly set up. To complete setup for remote access, log into the router and forward the port for the camera to
its IP address.
© 2014 Wirepath Surveillance
WPS-300-BUL-IP Installation Manual
37
Advertisement
Table of Contents
