Table of Contents
Advertisement
WPS-300-BUL-IP Installation Manual
9.2.4. System Update
•
Navigation: Log in as an administrator. From Home Screen, click "Config" button in top right corner, then click "System
Update" in left column "System" sub-menu.
Important! Firmware updates MUST be performed over a wired IP connection to ensure the connection is
sustained throughout the process. If connection is lost during update, use the IP Installer to find the device
and restart the update.
9.2.4.1.
Firmware Upgrade
See section
9.2.4.6. Upgrade the Firmware
1
Firmware
Current firmware version installed on the camera.
Version
New
Click "Browse" to search for a firmware file to upload from the PC to the camera.
Firmware
Click "Upgrade" (to the right) to upload the selected firmware in the "New Firmware" to the camera.
9.2.4.2.
Reboot System
Reboot the camera. No settings are changed.
2
Click "Start" to reboot the camera.
9.2.4.3.
Setting Management
See sections
9.2.4.4. How to Back Up Camera Settings
this feature.
Factory
3
Reset all settings to default. Click "Start" to begin the process.
Defaults
Load Settings
Click "Browse" to select a camera backup file to upload from the PC.
From:
Apply
Click the "Apply" button to load the backup file to the camera.
Remove
(Guest Accounts only) Click to remove the user account.
24
1
2
3
for instructions on using this feature.
and
9.2.4.5. Load Backup Settings to the Camera
for instructions on using
Advertisement
Table of Contents
