Network Traffic Camera (Multi-lens LPR Camera) User Manual
Chapter 8 Serial Port Configuration
8.1 Set RS-485
Set RS-485 parameters if the device needs to be connected to other peripheral devices controlled
by RS-485 serial port.
Before You Start
The corresponding device has been connected via the RS-485 serial port.
Steps
Note
The number of available RS-485 serial port varies with different models.
1. Go to Configuration → Device Configuration → System Configuration → Serial Ports .
2. Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3. Click Save.
8.2 Set RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port.
Before You Start
The debugging device has been connected via the RS-232 serial port.
Steps
1. Go to Configuration → System → System Settings → Serial Port → RS-232 .
Figure 8-1 Set RS-485
Figure 8-2 Set RS-232
41