HIKVISION iDS-TCH44P-B User Manual page 47

Network Traffic Camera (Multi-lens LPR Camera) User Manual
Select it when different LANs are connected. Set the IP addresses of different network
segments.
Note
The dual-NIC mode varies with different models. The actual device prevails.
3. Set the parameters below.
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IP Address
Two modes are available.
DHCP
The device automatically gets the IP parameters from the network if you check DHCP. The
device IP address is changed after enabling the function. You can use SADP to get the device
IP address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Configuration Protocol).
Manual
You can set the device IP parameters manually. Enter IP Address, Subnet Mask, and
Gateway.
IPv6
Three IPv6 modes are available.
Route Advertisement
The IPv6 address is generated by combining the route advertisement and the device Mac
address.
Note
Route advertisement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Enter IPv6 Address, IPv6 Subnet Mask, and IPv6 Gateway. Consult the network
administrator for required information.
MTU
37