Chapter 7 Serial Port Configuration; Set Rs-485; Set Rs-232 - HIKVISION iDS-TCD403-BI User Manual

Network Traffic Camera (for Traffic Flow Camera) User Manual

Chapter 7 Serial Port Configuration

7.1 Set RS-485

Set RS-485 parameters if the device needs to be connected to other peripheral devices controlled
by RS-485 serial port.
Before You Start
The corresponding device has been connected via the RS-485 serial port.
Steps
1. Go to Configuration → Device Configuration → System → Serial Port Parameters .
2. Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3. Click Save.

7.2 Set RS-232

Set RS-232 parameters if you need to debug the device via RS-232 serial port.
Before You Start
The debugging device has been connected via the RS-232 serial port.
Steps
1. Go to Configuration → Device Configuration → System → Serial Port Parameters .
2. Click Advanced Settings.
Figure 7-1 Set RS-485
Figure 7-2 Set RS-232
34