Network Traffic Camera (Multi-lens LPR Camera) User Manual
Chapter 3 Capture Configuration
3.1 Set Application Mode
3.1.1 Set License Plate Recognition
Set license plate recognition system when you need to recognize and capture the license plates of
the passing vehicles.
Steps
1. Go to Configuration → Device Configuration → Application Mode .
2. Set Application Mode as License Plate Recognition System.
3. Select a channel.
Note
It is only available between channel 2 and channel 3. Channel 1 is a fixed channel by default and
cannot be adjusted.
4. Select Trigger Type.
Video Detection
The passing vehicles will be recognized via videos. The capture mode is recommended as
Strobe Light Mode.
RS485
Select it when the vehicle detector is connected to the device via the RS-485 port.
5. Select Picture Mode.
Scene Picture
Only one passing vehicle picture will be output (including all objects in the field of view).
6. Select Detected Position.
Vehicle Tail
The license plate on the vehicle tail is detected.
Vehicle Head
The license plate on the vehicle head is detected. In this mode, you can enable Recording and
set Pre-record and Timeout.
7. Set Total Lanes according to actual needs.
8. Draw license plate recognition area.
1) Click Draw LPR Area.
2) Draw lane line, lane right limit, and trigger line according to the actual scene.
5