Firmware Update Tool For Ipf; Installing And Uninstalling On Hp_Ux; Figure 5-12 Swinstall Output - HP Integrity rx8620 User's & Service Manual

Troubleshooting

Firmware Update Tool for IPF

Firmware Update Tool for IPF
The OS Initate-able Firmware Update Tool for IPF enables the firmware update process to begin and end in
the operating system. Minimal interaction from the user is required. The tool runs only during installation
after which the system is rebooted.
NOTE The OS Initiat-able Firmware Update Tool for IPF can be used only when system firmware is
being upgraded and no other firmware components are to be updated.
In multi-cell systems, the tool updates the firmware for all the cells only in the partition from which the tool is
launched. All the other partitions are unaffected and continue to run on the previous version firmware. To
update all the partitions, the tool must be run on all the partitions.
NOTE The use of this tool is restricted to super users.

Installing and Uninstalling on HP_UX

Install
The following must be performed to update the firmware.
Enter the swinstall command.
# swinstall -x autoreboot=true -s /tmp/FUTests/OSIFU.depot PHSS_28608
Figure 5-12 swinstall output
126
Chapter 5