Using The Roni Model 17000 Sp 400 Lifting Device - HP Integrity rx8620 User's & Service Manual

Using the RonI Model 17000 SP 400 Lifting Device

A lifter designed by the RonI company is used to rack mount the server. The lifter can raise 400 lb. to a height
of five feet. The lifter can be broken down into several components. When completely broken down, no single
component weighs more than 25 lb. The ability to break the lifter down makes it easy to transport from the
office to the car and then to the customer site.
Documentation for the RonI lifter has been written by RonI and is on the HP intranet at the Cybrary Web
site. Complete details on how to assemble the lifter, troubleshoot the lifter, and maintain the lifter are
provided by RonI in the documentation.
Use the following procedure to unload the server from the pallet after the lifter is assembled.
WARNING Use caution when using the lifter. Because of the weight of the server, it must be
centered on the lifter forks before raising it off the pallet to avoid injury.
The server must be racked in the bottom of a cabinet for safety reasons. Never
extend more than one server from the same cabinet while installing or servicing
either an HP Integrity rx8620 Server or another server product. Failure to follow
these instructions could result in the cabinet tipping over.
Step 1. Obtain the HP J1528A Rack Integration Kit Installation Guide before proceeding with the rack
mount procedure. This guide covers these important steps:
• Installing the anti-tip stabilizer kit (A5540A)
• Installing the ballast kit (J1479A)
• Installing the barrel nuts on the front and rear columns
• Installing the slides
Step 2. Follow the instructions on the outside of the server packaging to remove the banding and carton top
from the server pallet.
Chapter 2
Using the RonI Model 17000 SP 400 Lifting Device
Installation
43